Structurally Sound Frames Built to Code

RLF Contracting llc provides framing carpentry for residential construction projects in Woodstock, Illinois.

You need walls, floors, and roof structures built square, plumb, and level before drywall or siding goes on. RLF Contracting llc handles framing carpentry in Woodstock for home additions, basement finishes, and new home construction. Studs are placed at correct intervals, headers are sized for load requirements, and plates are fastened to meet local building codes.

Each project starts with layout lines marked on slabs or subfloors. Walls are assembled, raised, and braced in place. Floor joists are crowned and spaced to prevent bounce, and roof rafters or trusses are set according to engineered plans. You will notice straight walls, level ceilings, and openings that are ready for windows, doors, and mechanical systems.

Request framing carpentry services for your Woodstock project.

How Framing Creates Long-Term Structural Integrity

Your framing starts with foundation measurements and chalk lines to ensure walls align with the building footprint in Woodstock. Bottom plates are anchored to concrete or subfloors using code-approved fasteners. Wall sections are built flat, then lifted and nailed into place with corner bracing to hold them square.

After framing is complete, you will see a stable structure with walls that do not shift or lean. Floor systems feel solid underfoot without squeaks or excessive movement. Roof framing is secure and ready to support sheathing, underlayment, and final roofing materials.

Headers above doors and windows are built from doubled lumber or engineered beams to carry loads from above. Studs are placed at sixteen or twenty-four inches on center depending on wall height and sheathing type. RLF Contracting llc follows engineered specifications and building codes to create frames that support long-term durability and safety.

What You Should Know Before Framing Starts

Homeowners in Woodstock often have questions about timelines, inspections, and what framing actually involves. These answers address the most common concerns before starting a framing project.

Black arrow pointing right.
What is the difference between stick framing and trusses?
Stick framing involves cutting and assembling individual rafters on site. Trusses are pre-built triangular frames delivered to the job and set in place with a crane or by hand, which speeds up roof framing.
Black arrow pointing to the right.
How long does it take to frame an addition?
Most single-story additions take one to two weeks to frame depending on size and complexity. Two-story additions or projects with custom roof lines take longer.
Black arrow pointing right.
Why do inspections happen during framing?
Building inspectors verify that framing meets structural codes before walls are covered. This includes checking stud spacing, header sizes, bracing, and fastener placement. RLF Contracting llc coordinates inspections and makes any required corrections.
Black arrow pointing right.
What happens if walls are not plumb or square?
Walls that are out of plumb create problems for drywall, trim, and cabinetry later in the project. RLF Contracting llc uses levels and string lines during framing to ensure walls are straight, square, and properly aligned before sheathing is applied.
Black arrow pointing right.
How do you frame around existing structures?
New framing is tied into existing walls or floor joists using metal connectors, blocking, or fasteners that transfer loads properly. The connection method depends on whether the addition is load-bearing and how the new structure integrates with the original home.

RLF Contracting llc frames residential projects across Woodstock including additions, basements, and new homes. Each structure is built with accurate layouts, proper fastening, and attention to code requirements that support long-term performance. Contact RLF Contracting llc to discuss your framing project and receive an estimate.